- A.SWEzonexam1(config-if)# switchport port-security maximum 1
- B.SWEzonexam1(config)# mac-address-table secure
- C.SWEzonexam1(config)# access-list 10 permit ip host
- D.SWEzonexam1(config-if)# switchport port-security violation shutdown
- E.SWEzonexam1(config-if)# ip access-group 10
- A.Full-duplex Ethernet uses CSMA/CD to prevent collisions.
- B.Half-duplex Ethernet uses a loopback circuit to detect collisions.
- C.A full-duplex Ethernet card allows 20Mbps for data transmission.
- D.Full-duplex Ethernet makes use of two pairs of wires for data.
- E.An Ethernet hub can operate both half and full duplex simultaneously.
- A.A switch
- B.A router
- C.A network adapter card
- D.A hub
- E.A repeater
- 6
-
Why is full-duplex Ethernet superior to its single-duplex counterpart? (Select two answer choices.)
- A.It uses inexpensive hubs
- B.It operates without collisions
- C.It operates on switches
- D.It provides faster data transfer
- E.It utilizes fewer wiring pairs
- A switch has been configured for three different VLANs: VLAN 2, VLAN 3, and VLAN 4. For the purposes of communication between VLANs a router is to be added. Host from one VLAN should be able to reach the hosts in the other VLANs.
- Based on this requirement, what type of connection is acceptable between the router and switch? (Select all valid answers)
- A.10 Mbps Ethernet
- B.56 kbps serial
- C.100 Mbps Ethernet
- D.1,544 Mbps serial
- E.1000 Mbps Ethernet
- A.A device waits for an electronic signal before transmitting.
- B.A device listens and waits until the media is not busy before transmitting.
- C.All devices on an Ethernet segment see data that passes on the network medium.
- D.Only the sender and the receiver devices see data that passes on the network medium.
- E.Ethernet networks allow you to configured devises with higher transmission priority.
- A.Allowing simultaneous frame. transmissions
- B.Increasing the size of broadcast domains
- C.Increasing the maximum length of UTP cabling between devices
- D.Filtering frames based on MAC addresses
- E.Decreasing the number of collision domains
- A.The extended ping command is supported from user EXEC mode.
- B.The extended ping command is available from privileged EXEC mode.
- C.With the extended ping command you can specify the TCP and UDP port to be pinged.
- D.With the extended ping command you can specify the timeout value.
- E.With the extended ping command you can specify the datagram size.
- A.Each device on the Ethernet segment stops transmitting for a short time.
- B.A jam signal informs all devices that a collision occurred.
- C.When data transmission resumes, the devices that were involved in the collision have priority to transmit.
- D.The devices that are involved in the collision stops transmitting for a short time.
- E.The collision invokes a random back-off algorithm.
- A.255.255.255.192
- B.255.255.255.224
- C.255.255.255.240
- D.255.255.255.248
- E.None of the above