单选

●代号 (14) 按中央所属企业或地方企业分别由国务院有关行政主管部门或省、自治区、直辖市政府标准化行政主管部门会同同级有关行政主管部门加以规定,没有强制性和推荐之分。

(14)

  • A.Q/XXX    &n
  • bsp;  B.DBXX    
  • C.QJ    
  • D.GSBXXX
参考答案
您可能感兴趣的试题

● (71) In the strength of the c

  • arrier signal is varied to represent
  • binary 1 or 0.    (72)  is a system that
  • can map a name to an a
  • ddress and conversely an address to an name.    (73) is a three-way handshaking authentication protocol that it's packets are encapsulated in the point-to-point protocol    (74) is an approach that enables
  • B.PSK
  • C.FSK
  • D.FDM    (72) A.NAT
  • B.NCP
  • C.DDN
  • D.DNS    (73) A.PPP

●对于不支持TCP/IP的设备 (64) 用SNMP进行管理。在SNMPV3中,以前叫做管理站和代理的东西现在统一叫做 (65) 。

(64)

  • A.可以    &n
  • bsp;  B.不能    
  • C.不能直接    
  • D.可以直接    (65) A.原语
  • B.对象
  • C.引擎
  • D.SNMP实体

●In the following ess

  • ay,each
  • blank has four
  • choices.Choose the best answer an
  • d write down on the answer sheet.    Microwave communication uses  (66) -frequency radio waves that travel in straightline sthrough the air.Because the waves cannot (67) with the curvature of the earth,they can
  • B.low
  • C.long
  • D.short    (67) A.reflex
  • B.distort
  • C.bend
  • D.absorb    (68) A.transmitted

●在Windows 2000操作系统中,配置IP地址的命令是 (59) 。若用ping命令来测试本机是否安装了TCP/IP协议,则正确的命令是 (60)  。如果要列出本机当前建立的连接,可以使用的命令是 (61) 。

(59)

  • A.winipcfg    &n
  • bsp;  B.ip
  • config
  • C.ipcfg    
  • D.winipconfig    (60) A.ping 127.0.0.0
  • B.ping 127.0.0.1
  • C.ping 127.0.1.1
  • D.ping 127.1.1.1    (61) A.netstat-s
  • B.netstat-o
  • C.netstat-a

●Socket的通信方式包括 (62) , (63) 是最常用的套接字类型。

(62)、(63)

  • A.字节流套接字    &n
  • bsp;       B.数据报套接字    
  • C.原始数据报套接字    
  • D.A、B和C

●在缺省配置的情况下,交换机的所有端口 (49) 。连接在不同交换机上的,属于同一VL

  • AN的数据帧必须通过&n
  • bsp;(50) 传输。    (49) A.处于直通状态
  • B.属于同一VL.AN    
  • C.属于不同VLAN    
  • D.地址都相同    (50) A.服务器
  • B.路由器
  • C.Backbone链路
  • D.Tfunk链路

●DES加密算法中,函数f的输出是 (51) 位。DES算法是分组密码,数据分组长度是 (52) 位。用软件方法实现DES一般至少比RS

  • A快100倍。DES通过&n
  • bsp;(53) 方法产生密文。    (51) A.8
  • B.16    
  • C.32    
  • D.64    (52) A.8
  • B.16
  • C.32
  • D.64    (53) A.累加
  • B.迭代
  • C.逻辑与

●以下关于集线器的分类,正确的是 (43) 。

(43)

  • A.无源(Passive)集线器、有源(Active)集线器和切换式集线路    &n
  • bsp;  B.插入式集线器、转接式集线器    
  • C.切换式集线器、共享式集线器和可堆叠共享式集线器    
  • D.共享式集线器和独立式集线器

●物理层的电气特性有多种标准,其中CCITT的V.11建议中规定 (44) 。常用的EI

  • A RS-232接口的电气特性与CCITT的&n
  • bsp;(45) 兼容,在这种电路中,数据"1"的接口电平规定为 (46) 。在RS-232定义的接口线中, (47) 表示计算机请求发送数据, (48) 表示计算机准备接收数据。    (44) A.发送器采用非平衡方式工作,接收器采用平衡方式工作
  • B.发送器采用平衡方式工作,接收器采用非平衡方式工作    
  • C.发送器和接收器都采用非平衡方式工作    
  • D.发送器和接收器都采用平衡方式工作    (45) A.V.35
  • B.V.11
  • C.V.24
  • D.V.28    (46) A.-3~-15V
  • B.+3~+15V
  • C.+5~+15V
¥

订单号:

遇到问题请联系在线客服

订单号:

遇到问题请联系在线客服