航海英语(甲类船长)船舶修理与保养单选题练习1

如果您发现本试卷没有包含本套题的全部小题,请尝试在页面顶部本站内搜索框搜索相关题目,一般都能找到。
1

You are testing the external inflation bladder on an immersion suit and find it has a very slow leak.Which action should be taken ________.

  • A.Replace the suit
  • B.Replace the inflation bladder
  • C.Take it out of service and repair in accordance with the manufacturers instructions
  • D.Some leakage should be expected and a topping off tube is provided; no other action is necessary
2

You are moving a gas free tank barge to dry dock for repairs.The barge must have onboard a valid ______.

  • A.Gas Free Certificate
  • B.Certificate of Inspection
  • C.Permit to Proceed and Hot Work Permit
  • D.All of the above
3

Why should you soak an anchor ________.

  • A.It can prevent the anchor from slipping during pretensioning
  • B.It will lubricate all the moving parts of a stock anchor
  • C.It will increase the maximum breaking strength of the anchor chain
  • D.It will make it easier to disassemble the anchor for repair
4

Which statement about two lines spliced together is TRUE ________.

  • A.Splicing is used to increase the circumference of each line
  • B.Splicing two lines together is stronger than knotting two lines together
  • C.Splicing is used to increase the overall strength of the line
  • D.Splicing is used to prevent rotting of the lines bitter end
5

Whipping the bitter end of a fiber rope ______.

  • A.increases the circumference of the rope
  • B.makes for easier handling
  • C.prevents fraying of the bitter end
  • D.prevents moisture from entering the bitter end
6

Which statement about the deck line is TRUE ________.

  • A.The top of the deck line is marked at the highest point of the freeboard deck,including camber,at the midships point
  • B.A vessel with wooden planks on a steel deck will have the deck line marked at the intersection of the upper line of the wood sheathing with the side shell
  • C.The deck edge is marked at the intersection of the freeboard deck with the side shell,at the lowest point of sheer,with the vessel at even trim
  • D.On a vessel with a rounded stringer-sheer plate,the deck line is marked where the stringer plate turns down from the plane of the deck line
7

Which statement about pneumatic chipping tools is TRUE ________.

  • A.The operator must wear safety goggles or glasses
  • B.The equipment must be grounded to prevent shock hazard
  • C.The chipping mechanism is made of a non-sparking material that is safe to use near explosive atmospheres
  • D.The needles of the needle-type chipping gun must be replaced when they have been blunted more than 1/2 of their diameter
9

Where do fatigue failures of wire rope mooring lines usually occur ________.

  • A.In the middle part of the line length
  • B.Near the socketed end fitting adjacent to the anchor
  • C.At the point where the line touches the bottom
  • D.At the place the anchor buoy is attached to the line
10

Which bend or knot is used to tie a small line to a larger one ________.

  • A.Becket bend
  • B.Bowline
  • C.Clove hitch
  • D.Lark's head
13

To prevent a wooden hull from leaking you caulk it ______.

  • A.after drydocking,while the hull is moist
  • B.after drydocking,and the hull has dried
  • C.afloat,where it is leaking
  • D.afloat,in all accessible areas
14

Topside area from deep loadline to bulwark to be thoroughly washed down with ______.

  • A.highly pressure fresh water
  • B.high pressured fresh water
  • C.highly pressured fresh water
  • D.high pressure fresh water