The 213.115.77.0 network was subnetted using a /28 subnet mask. How many usable subnets and host addresses per subnet were created as a result of this?

A. 2 networks with 62 hosts

B. 6 networks with 30 hosts

C. 16 networks and 16 hosts

D. 62 networks and 2 hosts

E. 14 networks and 14 hosts

F. None of the above

You need to configure an 802.1Q link on a Ezonexam switch. Which commands, when used together, would do this? (Select two answer choices)

A. Switch(vlan)# mode trunk

B. Switch(config)# switchport access mode trunk

C. Switch(config-if)# switchport mode trunk

D. Switch(config-if)# switchport trunk encapsulation dot1q

E. Switch(config)# switchport access mode 1

F. Switch(vlan)# trunk encapsulation dot1q

What will cause a Ezonexam router to enter setup mode? (Choose two)

A. The configuration file is missing in NVRAM.

B. The configuration register is set to 0x2100.

C. Boot system commands are misconfigured in the running-configuration.

D. The setup command was issued from the privileged mode prompt.

E. The IOS is missing.

F. The IOS is corrupt.

The 213.115.77.0 network was subnetted using a /28 subnet mask. How many usable subnets and host addresses per subnet were created as a result of this?

A. 2 networks with 62 hosts

B. 6 networks with 30 hosts

C. 16 networks and 16 hosts

D. 62 networks and 2 hosts

E. 14 networks and 14 hosts

F. None of the above

The network 172.25.0.0 has been divided into eight equal subnets. Which of the following IP addresses can be assigned to hosts in the third subnet if the ip subnet-zero command is configured on the router? (Choose three)

A. 172.25.78.243

B. 172.25.98.16

C. 172.25.72.0

D. 172.25.94.255

E. 172.25.96.17

F. 172.25.100.16

You are logged into a router and wish to view the layer 3 information about your neighboring Cisco routers. What IOS command gives layer 3 information for of the directly connected router interfaces?

A. show ip links

B. show cdp neighbor

C. show cdp neighbor detail

D. show ip clients

E. show ip route

F. None of the above

What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology?

A. path cost

B. lowest port MAC address

C. VTP revision number

D. highest port priority number

E. port priority number and MAC address

F. None of the above

You have set up an Internet based FTP server, where people can upload and download files. In terms of the OSI model, what is the highest layer used during the FTP sessions.

A. Application

B. Presentation

C. Session

D. Transport

E. Internet

F. Data Link

G. Physical